This time is a capacitor spot welder
My capacitance
55 capacitors
Casually welded
First plug the capacitor into the hole plate. Here is a little trick to facilitate solder joints. (I don't know if it is counted)
First plug in the capacitor, (the positive and negative poles do not mix, the mixture will leak, it is very troublesome), put the capacitors in a row, unify the positive electrode to the outside, the negative pole, then insert a row of capacitors, the same negative Inward, it is the positive pole to the positive pole or the negative pole to the negative pole and then soldered like me
back
In the figure, the solder is smashed because the capacitor is inserted, it is an accident. It has been soldered down for a long time. It is charged a little more, and the capacitor is charged. After a while, the capacitor is probably charged, and then the positive or negative clamp of the capacitor. On the alligator clip, use the wire to pull out, and then wire or wire on an electrode clip, I use the needle of the scrapped multimeter, and the other end is connected to the item to be welded. The effect is good. Only 12 can be used to weld the paper clip.
Crocodile clip
Sauce purple inserted into the hole plate, pay attention to the positive and negative
12v10a power supply
Sponsored capacitors, and my power supply
Temporarily welded
The head used for welding, I don’t know what to call.
Link:Tenco
没有评论:
发表评论